12 valve Cummins engine running W250 W350 D250 D350 2500 3500 - $3,900 (Auburn)
Report Ad
Whatsapp
Posted : Wednesday, September 04, 2024 12:02 AM
1993 studded 12 valve Cummins.
Engine is just installed into a parts truck frame.
Bring your 2nd opinions/mechanic buddy’s and come hear it run before we load.
Sold the project this was going in.
The W250 truck I pulled this engine from had 225k miles and was not running because the VE pump was leaking pretty bad so the old owner pulled the lines and VE pump.
I have pictures and receipts to prove parts on engine.
New parts have 0 miles on it since I put it together.
I’ve build at least a dozen of these engines, I’m very familiar with them.
I’ve owned 30 plus of these trucks with these engines.
New Mahle head gasket
New DCEC VE pressure lift pump
New injectors
New billet tapper cover
New rocker pedestals
New xotic head studs
New engine gasket and seal kit
New Bosch VE pump
New dual valve cover breathers
New gates water pump
New gates belt tensioner
New KDP tab
New fuel and oil filter (Rotella T5 15-40)
New exhaust studs
New oil pressure sensor
New PJ1 satin engine paint
Resealed vacuum/power steering pump
Engine does not leak a drop.
EVERY gasket and seal replaced.
Comes with (not shown) is a good used Alternator, fan, fan bracket, belt, a/c compressor, intercooler tubes and boots, and intercooler.
Only thing engine needs is fuel line clamps(they were lost/not in truck when I bought it) and a catch can set up for the billet tapper cover.
Other than that, it’s ready to install into your project.
$3900 Firm for everything mentioned.
No trades of any kind cash only.
Located in Auburn, Ca 95603
5threezero-threesixzero-895one
• Phone : NA
• Location : Auburn,CA
• Post ID: 9110167129
Posted : Wednesday, September 04, 2024
Posted : Wednesday, September 04, 2024
Posted : Wednesday, September 04, 2024
Posted : Wednesday, September 04, 2024
Posted : Wednesday, September 04, 2024