Blown Small Block Chevy "Hat to Pan"
Check out this slightly used Blown Small Block Chevy "Hat to Pan" that was assembled by Rick Santos at S&S Automotive.
Drop this one in your Front or Rear Engine Dragster, Alcohol Funny Car, Blown Altered, Pro Street, Hot Rod, Drag Boat, Tractor Puller and hold on!!! This is the perfect opportunity to outfit your ride with quality components.
And get the job done all in one place!!! So on with the show.
.
.
• Rodeck Cast Aluminum Block (Water Block, 4.
155 Sleeves, Standard Mains, .
903 Lifters)
• Brodix -12 Aluminum Water Heads (Professionally Ported, Set up to run Down Nozzles)
• Titanium Intake & Exhaust Valves
• K-Motion Valve Springs
• Jesel Shaft Rockers (1.
6 Ratio)
• Enderle "Birdcatcher" Injector (Polished, Completely Plumbed, Hoses, Dist.
Block, Nozzles)
• Enderle "K" Style Barrel Valve
• Littlefield 12-71 Supercharger (Polished, RCD Magnesium Snout)
• DJ Blower Restraint
• Custom S&S Automotive Intake Manifold (Remove it without removing the magneto)
• Mallory Super Mag (Mallory Plug Wires included)
• Dunn Mag Drive (Offset Style, Includes PSI Rev-Limiter)
• Kinsler 12 GPM Fuel Pump (Not Pictured)
• Crower Crankshaft (3.
500 Stroke, Recent Magnaflux, Standard Mains)
• RCD Magnesium Idler Assembly (Light weight)
• RCD Bearing Support (Save even more weight)
• Jesel Belt Drive
• Crane Roller Camshaft (Brand new)
• JE Pistons & GRP Aluminum Rods
• Bullet Roller Lifters (Brand New).
• Moroso Aluminum Oil Pan & System 1 Oil Pump
• And much more.
.
.
Why buy elsewhere?
As you probably know, you could easily spend over $30,000 to duplicate a set-up similar to this one.
And then spend months shopping around trying to line up all these different components that are included in this very special package.
.
.
This engine is available immediately, will sell for thousands less than the price of new and ready to ship out today!
Priced to move at: Only $24,500.
All reasonable offers considered.
If you have any questions please email.
Thanks for checking.